Dual Video Dual Audio 2-FBNC 2-RCA to
RJ45 Jack from ComputerCableStore™. The ETS PV900 and PV901 Baseband Audio/Video Baluns are utilized for point-to-point replacement of coaxial (video) and shielded (high impedance audio) cables with UTP wiring, Category 5 is better.
The PV900 (with a
BNC video input plus dual
RCA jacks for audio) and the PV901 (with 3 RCA jacks for all inputs) are designed for installations that have a need for separate audio channels. For example, some VCRs and Video Cameras have video plus stereo outputs available on three RCA jacks. The PV901 can run these signals using three or four pairs in standard UTP cable.
New to the series are the PV905 and the PV906, which allow you to send two channels each of baseband video and audio in any direction desired. This capability yields, for instance, a bi-directional video + mono audio link, or many other configurations.
Features/AdvantagesThe 8 Position 8 Contact (8P8C) (often called RJ45) plugs and sockets are most regularly used as an ethernet connector. 8P8C connectors are typically used to terminate twisted pair cable.
An RCA jack, also referred to as a phono connector or Cinch connector, is a type of electrical connector that is commonly used in the audio/video market. The name "RCA" derives from the Radio Corporation of America, which introduced the design by the early 1940s to allow mono phonograph players to be connected to amplifiers.
The BNC (Bayonet Neill Concelman) connector is a very common type of RF connector used for terminating coaxial cable. The BNC connector is used for RF signal connections, for analog and Serial Digital Interface video signals, amateur radio antenna connections, aviation electronics (avionics) and many other types of electronic test equipment. It is an alternative to the RCA connector when used for composite video on commercial video devices, although many consumer electronics devices with RCA jacks can be used with BNC-only commercial video equipment via a simple adapter. BNC connectors were commonly used on 10base2 thin Ethernet networks, both on cable interconnections and network cards, though these have largely been replaced by newer Ethernet devices whose wiring does not use coaxial cable. Some ARCNET networks use BNC-terminated coax.
- 1 baseband video channel and 2 balanced audio
- Use for point to point replacement of coax and shielded cables
- Rugged plastic case
- Made in USA. 100% QA. Specifications
- Bandwith Flat to 60 MHz (video) / 10 Hz to 20 kHz (audio)
- Connectors BNC to RCA (video) / (2) RCA or Screw Terminals (audio) to RJ45 (pairs 2, 3 & 4)
- Crosstalk 50dB (video)
- Impedence 600:600 (audio)
- Isolation 500 V (audio, per channel)
- Dimensions 66mm x 66mm x 28mm