Other Cables and Accessories

An RCA jack, also referred to as a phono connector or Cinch connector, is a type of electrical connector that is commonly used in the audio/video market. The name "RCA" derives from the Radio Corporation of America, which introduced the design by the early 1940s to allow mono phonograph players to be connected to amplifiers.

A patch cable or patch cord (sometimes patchcable or patchcord) is an electrical or optical cable, used to connect ("patch-in") one electronic or optical device to another for signal routing. Devices of different types (ie: a switch connected to a computer, or switch to router) are connected with patch cords. Patch cords are usually produced in many different colours so as to be easily distinguishable, and are relatively short, perhaps no longer than two metres. Types of patch cords include microphone cables, headphone extension cables, XLR connector, RCA connector and 1/4" TRS connector cables (as well as modular ethernet cables), and thicker, hose-like cords (snake cable) used to carry video or amplified signals. However, patch cords typically only refer to those short ones used with patch panels.

The BNC (Bayonet Neill Concelman) connector is a very common type of RF connector used for terminating coaxial cable. The BNC connector is used for RF signal connections, for analog and Serial Digital Interface video signals, amateur radio antenna connections, aviation electronics (avionics) and many other types of electronic test equipment. It is an alternative to the RCA connector when used for composite video on commercial video devices, although many consumer electronics devices with RCA jacks can be used with BNC-only commercial video equipment via a simple adapter. BNC connectors were commonly used on 10base2 thin Ethernet networks, both on cable interconnections and network cards, though these have largely been replaced by newer Ethernet devices whose wiring does not use coaxial cable. Some ARCNET networks use BNC-terminated coax.

A patch cable or patch cord (sometimes patchcable or patchcord) is an electrical or optical cable, used to connect ("patch-in") one electronic or optical device to another for signal routing. Devices of different types (ie: a switch connected to a computer, or switch to router) are connected with patch cords. Patch cords are usually produced in many different colours so as to be easily distinguishable, and are relatively short, perhaps no longer than two metres. Types of patch cords include microphone cables, headphone extension cables, XLR connector, RCA connector and 1/4" TRS connector cables (as well as modular ethernet cables), and thicker, hose-like cords (snake cable) used to carry video or amplified signals. However, patch cords typically only refer to those short ones used with patch panels.

The BNC (Bayonet Neill Concelman) connector is a very common type of RF connector used for terminating coaxial cable. The BNC connector is used for RF signal connections, for analog and Serial Digital Interface video signals, amateur radio antenna connections, aviation electronics (avionics) and many other types of electronic test equipment. It is an alternative to the RCA connector when used for composite video on commercial video devices, although many consumer electronics devices with RCA jacks can be used with BNC-only commercial video equipment via a simple adapter. BNC connectors were commonly used on 10base2 thin Ethernet networks, both on cable interconnections and network cards, though these have largely been replaced by newer Ethernet devices whose wiring does not use coaxial cable. Some ARCNET networks use BNC-terminated coax.

A patch cable or patch cord (sometimes patchcable or patchcord) is an electrical or optical cable, used to connect ("patch-in") one electronic or optical device to another for signal routing. Devices of different types (ie: a switch connected to a computer, or switch to router) are connected with patch cords. Patch cords are usually produced in many different colours so as to be easily distinguishable, and are relatively short, perhaps no longer than two metres. Types of patch cords include microphone cables, headphone extension cables, XLR connector, RCA connector and 1/4" TRS connector cables (as well as modular ethernet cables), and thicker, hose-like cords (snake cable) used to carry video or amplified signals. However, patch cords typically only refer to those short ones used with patch panels.

The BNC (Bayonet Neill Concelman) connector is a very common type of RF connector used for terminating coaxial cable. The BNC connector is used for RF signal connections, for analog and Serial Digital Interface video signals, amateur radio antenna connections, aviation electronics (avionics) and many other types of electronic test equipment. It is an alternative to the RCA connector when used for composite video on commercial video devices, although many consumer electronics devices with RCA jacks can be used with BNC-only commercial video equipment via a simple adapter. BNC connectors were commonly used on 10base2 thin Ethernet networks, both on cable interconnections and network cards, though these have largely been replaced by newer Ethernet devices whose wiring does not use coaxial cable. Some ARCNET networks use BNC-terminated coax.

A patch cable or patch cord (sometimes patchcable or patchcord) is an electrical or optical cable, used to connect ("patch-in") one electronic or optical device to another for signal routing. Devices of different types (ie: a switch connected to a computer, or switch to router) are connected with patch cords. Patch cords are usually produced in many different colours so as to be easily distinguishable, and are relatively short, perhaps no longer than two metres. Types of patch cords include microphone cables, headphone extension cables, XLR connector, RCA connector and 1/4" TRS connector cables (as well as modular ethernet cables), and thicker, hose-like cords (snake cable) used to carry video or amplified signals. However, patch cords typically only refer to those short ones used with patch panels.

The BNC (Bayonet Neill Concelman) connector is a very common type of RF connector used for terminating coaxial cable. The BNC connector is used for RF signal connections, for analog and Serial Digital Interface video signals, amateur radio antenna connections, aviation electronics (avionics) and many other types of electronic test equipment. It is an alternative to the RCA connector when used for composite video on commercial video devices, although many consumer electronics devices with RCA jacks can be used with BNC-only commercial video equipment via a simple adapter. BNC connectors were commonly used on 10base2 thin Ethernet networks, both on cable interconnections and network cards, though these have largely been replaced by newer Ethernet devices whose wiring does not use coaxial cable. Some ARCNET networks use BNC-terminated coax.

A patch cable or patch cord (sometimes patchcable or patchcord) is an electrical or optical cable, used to connect ("patch-in") one electronic or optical device to another for signal routing. Devices of different types (ie: a switch connected to a computer, or switch to router) are connected with patch cords. Patch cords are usually produced in many different colours so as to be easily distinguishable, and are relatively short, perhaps no longer than two metres. Types of patch cords include microphone cables, headphone extension cables, XLR connector, RCA connector and 1/4" TRS connector cables (as well as modular ethernet cables), and thicker, hose-like cords (snake cable) used to carry video or amplified signals. However, patch cords typically only refer to those short ones used with patch panels.

The BNC (Bayonet Neill Concelman) connector is a very common type of RF connector used for terminating coaxial cable. The BNC connector is used for RF signal connections, for analog and Serial Digital Interface video signals, amateur radio antenna connections, aviation electronics (avionics) and many other types of electronic test equipment. It is an alternative to the RCA connector when used for composite video on commercial video devices, although many consumer electronics devices with RCA jacks can be used with BNC-only commercial video equipment via a simple adapter. BNC connectors were commonly used on 10base2 thin Ethernet networks, both on cable interconnections and network cards, though these have largely been replaced by newer Ethernet devices whose wiring does not use coaxial cable. Some ARCNET networks use BNC-terminated coax.